Therefore, you are halfway in order to configure the username and password for the admin. This will surely enhance the security of your network, as everyone will not have the access to your network.
Configuring 192.168.10.1 Login Admin Username Password
As you are on the admin panel, therefore, you will see the various options for the configuration of your repeater. Therefore, in order to change the username and password, you need to go with the following instructions:
- Step 1: From the available tabs, select the Management tab for the settings of the username and password.
- Step 2: Then, again the list of options will open, select Password from that.
- Step 3: Now, enter the new password that you want to use.
- Step 4: Again, reconfirm it for making it sure.
- Step 5: Then, select the username option and change the username in the same way.
- Step 6: Save the changes to apply that.
- Step 7: Reboot your repeater, and try again to log in with the new credentials.
Note: In some admin panels, there used to be the option of General Settings instead of the Management tab.
If you are able to log in successfully with the changed credentials, then it means you have successfully configured it. Now, it won’t be easy for outsiders to login into your network. Due to some reasons, if you are not able to login into the network, then follow the troubleshooting steps.
Troubleshooting wifi repeater 192.168.10.1
To troubleshoot the login problem, follow the steps given below:
- Step 1: Make sure, you are using the right IP address for the login, and no digit is miswritten in between.
- Step 2: Try to connect to the system with an ethernet cable in case you are using the wireless method.
- Step 3: Check that the router has no fault in it, and all the LEDs are lighting properly.
This guide has explained properly about the 192.168.10.1 Login Admin Username Password. Therefore, if you have any issue with the login or configuration of the wireless repeater 192.168.10.1, then you can follow the above steps without any hesitation. By the end, you will be able to get the results that you want.